DIY Witch Leg Table Runner

331
0
Share:

Table runners are a great way to decorate for any season! When I found these witch legs at the dollar tree I an idea for a table runner that turned out so cute and it was also super easy! Make sure you watch the video at the bottom of this post if you need help with any of the steps! 

 

What you need:

Two sets of witch legs from the Dollar Tree
Table runner (you can buy one or make one. Mine is made out of burlap and it is 50 inches long, 15 inches wide)
Hot glue gun
Glue
Scissors
Ribbon

Step 1:
Make your runner if you didn’t purchase one for this project. Fold ends over and hot glue to make an edge on each end.

Step 2:
Lay your runner down and decide how long you want your witch legs to be. All of them need to be the same length, I decided on 7 inches from the edge of my runner.

Step 3:
Decide on how far apart your legs need to be. I did mine 2 1/2 inches from the outside edge.

Step 4:

Have the good side of the table runner facing up and glue the legs to the back side.

Step 5:
Measure a piece of ribbon of your choice. It should be double the width of your table runner. For example, my runner is 15 inches wide, so my ribbon is 30 inches.

Step 6:
Fold the piece of ribbon in half and lay it down on the front of your runner. The middle should be between the two legs on the front.

Step 7:
Glue the ribbon down on the front, make sure you get the top edge and the bottom edge.

Step 8:
Turn it over and glue the back side to finish off the project. This gives the runner weight so it hangs straight off the end of your table.

 

 

Happy Crafting!

 

DIY Witch Legs Table runner👻🎃
Make it with me here⬇️⬇️⬇️ Made with Dollar Tree Witch Legs🎃🎃⬇️

Posted by C Whimsy on Tuesday, September 18, 2018

Share: